Once programmed, the keypad remains active for 15 seconds. Keypad will light steadily for 5 seconds: After pressing any key or after entering a correct PIN. Do not clear and start over as first door programming will be erased. If unsuccessful, wait until keypad stops flashing, then begin at step 1. To program a second garage door opener brand after successfully programming the first: Determine brand, then follow the brand steps, choosing a different PIN and in step 1 enter 5,6,7,8 instead of 1,2,3,4. Keypad will flash: During certain programming sequences - when pressing the or # key or an incorrect PIN is entered. This erases previous programming and returns unit to unprogrammed factory setting. If both keys are not pressed down at the same time, the keypad flashes 10 1/2 second flashes, followed by 5 one second flashes. (Do not use the or # Key)Ĭlear and start over: Press and # together until keypad stops flashing When flashing stops, just re-enter the correct PIN followed by any 5th additional number. If an incorrect PIN is entered, the keypad flashes. After programming is complete, your PIN plus any additional number must be entered to activate your system. You must choose a 4-digit Personal Identification Number (PIN) when programming the CLK1. Master Mechanic, Do It - ( Orange/Red Learn (9 Code Switch Systems, Yellow, White or GrayĢ Chamberlain, Sears, LiftMaster, Master Mechanic, The receiver can be mounted on the back or side panel or could be mounted on the ceiling or wall.ġ Chamberlain, Sears, LiftMaster, Master Mechanic, THE CLICKER IS NOT COMPATIBLE WITH SOME ROTATING SUCH AS GENIE INTELLICODE OR STANLEY SECURE CODE OPENER SYSTEMS DEVELOPED BY SEVERAL MANUFACTURERSĭetermine your brand from an original hand held remote or receiver.
0 Comments
Leave a Reply. |